Cadillac seville 2002 Benutzerhandbuch

2. Press the “Learn” or “Smart” button on the garage

door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.

Following this step, you have 30 seconds to start Step 3.

3. Return to HomeLink in your vehicle and firmly press

and release the programmed HomeLink button 
three times.

The rolling

-

code garage door opener should now

recognize HomeLink. You may either use HomeLink 
or the hand

-

held transmitter to open the garage door.

If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1

-

800

-

355

-

3515, or on

the internet at www.homelink.com.

Canadian Owners: During programming, the hand

-

held

transmitter may automatically stop transmitting after 
two seconds. In this case, you should press and 
hold the HomeLink button (see Steps 2 and 3 under
“Programming the HomeLink Transmitter”) while you
press and re

-

press (cycle) your hand

-

held transmitter

every two seconds until HomeLink is trained.

To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.

To reset HomeLink to default settings, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Continue to hold both
buttons until the HomeLink indicator light turns off and
then release both buttons.

Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please contact the manufacturer
of HomeLink at 1

-

800

-

355

-

3515, or on the internet 

at www.homelink.com.