Fujitsu plasmavision p42hta51e Benutzerhandbuch
E-15
Engli
sh
Deutsch
Esp
a
ñol
Fran
ç
ais
Italiano
Portu
gu
ê
s
日 本 語
Póññêèé
中文
RGB INPUT MODE
1
Press
to select the input mode.
The input terminal of RGB mode is as follows.
• RGB1: mD-sub
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E-25.
P. E-25.
CONVENIENT FUNCTIONS
DISPLAY
Displaying on-screen information.
Press
3
.
The channel or mode is indicated on the screen for 5 seconds.
PICTURE MODE
Press
4
.
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see “Picture Mode (P. E-20)”.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see “Picture Mode (P. E-20)”.
PICTURE MEMORY
Press
5
.
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
pressed, the setting changes as follows.
* For the picture memory settings, see “Picture Memory (P. E-21)”.
DUAL CHANNEL
Press
G
.
This function enables selection of the audio mode when there is a dual-channel broadcast. Each time this
button is pressed, the mode is switched as shown in the figure below.
button is pressed, the mode is switched as shown in the figure below.
Depending on the broadcast, this function may not be available.
OFF-TIMER
Press
7
.
This can be used to set the time before the power is turned off (Stand-by state). Each time this button is
pressed, the setting changes as follows.
pressed, the setting changes as follows.
Note
• Functions may not be available with some models and some device options.
RGB1 mode
Memory1
Memory2
Memory3
Memory4
Memory5
Memory6
Memory7
Memory8
Dual-I
Dual-II
Stereo
Mono
Off
30 min.
60 min.
90 min.
120 min.
01_E_7473.book 15 ページ 2006年9月6日 水曜日 午後2時36分