Fortinet fortigate-100a Benutzerhandbuch

In the Map to IP section, type the IP address of the FortiGate unit on the internal 
network.
If the FortiGate unit is operating in NAT/Route mode, enter the IP address of the 
external interface.
If the FortiGate unit is operating in Transparent mode, enter the management IP 
address.

Set the Map to Port to 9443.

Select OK.

Add a new external to internal firewall policy.

Configure the policy with the following settings:

Select OK.

Go to System > Maintenance > Update center.

Select the Allow Push Update check box.

Select the Use override push check box.

Set IP to the external IP address added to the virtual IP.

Set Port to the external service port added to the virtual IP.

Select Apply.
The FortiGate unit sends the override push IP address and port to the FDN. The FDN 
now uses this IP address and port for push updates to the FortiGate unit on the 
internal network.
If the external IP address or external service port changes, add the changes to the 
Use override push configuration and select Apply to update the push information on 
the FDN.

You can select Refresh to make sure that push updates work.
Push Update changes to Available.

You can use the Support page to report problems with the FortiGate unit to Fortinet 
Support or to register your FortiGate unit with the FortiProtect Distribution Server 
(FDS).

External_All

The virtual IP added above.

Always

ANY

Accept

Selected.