LiftMaster rsw12vh Benutzerhandbuch

The dual gate wiring kit is 40 feet of interconnecting cable required for dual gate 
applications.
Model MSWIRE12GA6C

SLEEP MODE
The operator enters sleep mode 10 seconds after the last command is given. The photoelectric sensor indicator LEDs 
will not be on. The next command given will return the operator to normal operation.

REMOTE CONTROL
Once the remote control has been programmed operator will operate as follows:
When gate is in the closed position, activation of the remote control button will open the gate. During the open cycle 
another activation of the remote control will stop the gate and the next activation of the remote control will close 
the gate. When the gate is in the open position, activation of the remote control button will close the gate.

If a contact sensor detects an obstruction twice consecutively the alarm will sound 
(up to 5 minutes) and the operator will need to be reset.

The gate does not meet 
specifications.

Debris is on the gate's track 
such as mud, rocks, dirt, etc. 
(Slide Only)

The gate has one or more 
broken axles or wheels. 
(Slide Only)

The gate wheel is off the gate 
rail. (Slide Only)

The gate is hitting a wall or 
vehicle.

NOTE: In dual gate applications the reset switch/button must be toggled/pressed on the primary operator.

Remove any obstructions. Toggle/press the reset switch/button to shut off the alarm and reset the operator. After 
the operator is reset, normal functions will resume. 

When the inherent force of the operator (RPM/current 
sensor) detects the following (twice consecutively) the 
alarm will sound (up to 5 minutes) and the operator 
will need to be reset:

The remote antenna extension kit allows the antenna to be remotely installed.
Model 86LM

Access control receiver for up to 450 Security✚

 remote controls.

Model STAR450-315

Keeps operator gearbox and batteries at suitable temperature when outside 
temperature is below 0°F for extended periods of time.
Models HTRKITRSL (for Slide operator, includes bracket for optimal 7AH battery 
location) and G6518SL (Slide replacement heater only)
Models HTRKITRSW (for Swing operator, includes bracket for optimal heater 
location) and G6518CSW (Swing replacement heater only)

Low power loop detectors.
Model LD7LP

For Model RSL Slide. Ideal to raise slide operator higher above the ground for snow 
and other applications.
Model MSLM for Slide ONLY

Gate hinges are too tight or 
broken and the gate is not 
moving freely. (Swing Only)

The gate is moving and a car 
pushes the gate. 
(Swing Only)

A foreign object is on the gate 
frame while the gate is moving.
(Swing Only)

The gate hits the driveway, curb 
or other, and gets stuck or bent 
in an awkward position. 
(Swing Only)

The operator arm or gate is 
incorrectly installed. 
(Swing Only)

ACCESSORIES

OPERATION

5

2

POST-MOUNTING PLATE
For post-mounting model RSW residential swing operator (also CSW200 
commercial swing operator). Posts not included.
Model MPEL

 for Swing ONLY