Furuno navnet drs25a Benutzerhandbuch

For DRS2D/4D

1. Remove mounting hardware at the bottom of the radar sensor, four each of hex bolts 

(M10x20), spring washers and flat washers. Save the spring washers and flat washers to use 
them to fix the radome base to the platform, at step 3. If the thickness of the mounting platform 
is 5 mm or less, also save the bolts.

2. Construct a platform (steel or aluminum) 6-10 mm in thickness referring to the outline drawing 

at the back of this manual. Fasten the platform to the mounting location. Next, position the 
base so the cable entrance is facing the stern.

Note: When drilling holes in the platform, be sure they are parallel with the fore and aft line.

Radar sensor

Radar sensor

Radar sensor

Radar sensor

Screws

(two screws on other side)

Stern

Bow

Cable entry

Hex bolt (M10 x 20)

Spring washer

Flat washer