Furuno fmd-1712 Benutzerhandbuch
7
1.15 Measuring the Bearing
The bearing to a target can be measured by
the cursor (see paragraph 1.12) and by the
EBL (Electronic Bearing Line).
the cursor (see paragraph 1.12) and by the
EBL (Electronic Bearing Line).
Measuring bearing by the EBL
1. Press the [EBL] key to turn on the EBL.
2. Within 10 seconds after turning on the
2. Within 10 seconds after turning on the
EBL, that is, while "EBL" is highlighted at
the bottom left-hand corner on the
screen, press (counterclockwise) or
(clockwise) to bisect the target with EBL.
the bottom left-hand corner on the
screen, press (counterclockwise) or
(clockwise) to bisect the target with EBL.
3. Check the EBL readout at the bottom
left-hand corner on the screen.
Note: The EBL becomes stationary when
the [EBL] key is pressed a second
time, or 10 seconds elapses without
pressing or . When the EBL is
stationary "EBL" is not highlighted.
time, or 10 seconds elapses without
pressing or . When the EBL is
stationary "EBL" is not highlighted.
2.0
EBL
45.0
°
045.0
°
3.35
NM
Target
EBL
EBL
bearing
bearing
Cursor
Cursor
bearing
bearing
6.0
NM
Figure 1-13 Measuring bearing by
the cursor and the EBL
To erase the EBL, press the [EBL] key until
the EBL disappears.
the EBL disappears.
1.16 Shifting the Display
Your vessel's position can be shifted
backward by 1/3 of the range to increase
the forward range without changing the
range or size of targets.
backward by 1/3 of the range to increase
the forward range without changing the
range or size of targets.
Press the [SHIFT] key to turn the shifted
display on/off.
display on/off.
Press
[SHIFT]
Normal display Shifted display
Figure 1-14 Shifting the display
1.17 Zoom
The zoom feature allows you to double the
size of the area between your vessel and
any location within the current range to take
a closer look at an area of interest.
size of the area between your vessel and
any location within the current range to take
a closer look at an area of interest.
1. Select location to zoom with the cursor.
2. Press the [ZOOM] key.
2. Press the [ZOOM] key.
Cursor
Cursor
1) Place cursor
where desired.
where desired.
2) Press [ZOOM].
Press
[ZOOM]
ZOOM
ZOOM on (flashing)
Figure 1-15 Zoom function
3. To turn off the zoom function, press the
[ZOOM] key again.
Note 1: Zoom is inoperative when the
display is shifted.
Note 2: Zoom is not available on the 0.125
(1/8) nm range.