fetco cbs-31a Benutzerhandbuch
7
Operating Procedures
1. Turn the power switch
(A)
to the on position
• The power switch will illuminate to indicate that the brewer has power and is operating.
• When
• When
the
ready light
(B)
illuminates, the brewer is fully up to temperature. The amount of time
required to gain full operating temperature will vary depending on the electrical configuration that was
ordered, and the temperature of the incoming water.
ordered, and the temperature of the incoming water.
2. Prepare the brew baskets
(F)
.
• Place a paper filter in each basket to be used. Pour the appropriate amount of pre-measured, ground
coffee into the filter. The amount of coffee used will depend on your personal tastes and the
recommendation of your roaster.
recommendation of your roaster.
• Slide the brew basket back into the rails on the brewer.
• Select full or half batch mode
• Select full or half batch mode
(C)
(optional).
3. Prepare the dispenser(s).
• Ensure that the dispensers are empty. If you are using
airpots, open the cover and remove the pump stem
before brewing.
before brewing.
• Place the dispensers in position under the brew
baskets.
4. Press the brew switch
(D)
to start the brew cycle.
• The brew light
(E)
will illuminate, verifying that the brew
cycle has begun.
• It is normal for the ready light to go out after the start of
the brew cycle. On twin brewers, there is enough hot
water in the brewer to support a second brew, even if
the ready light is off. After brewing on both sides, you
must wait for the ready light to come back on.
water in the brewer to support a second brew, even if
the ready light is off. After brewing on both sides, you
must wait for the ready light to come back on.
• The electrical configuration and the electrical power connected to the brewer will determine how long
before the ready light comes back on for the next brew.
• If it is necessary to interrupt the brew cycle before it is finished, press the stop switch
(G)
.
5. You now have a dispenser of freshly brewed coffee, ready to serve, that will taste fresh and stay hot.
ONLY a non-heated dispenser can do that.
• If you are using airpots, insert the pump stem before closing the cover.
CAUTION:
Do not remove the brew basket immediately after the brew cycle has finished. Wait until
dripping from the bottom of the brew basket has stopped. Carefully remove the brew basket
while inspecting the inside of the basket for hot coffee that has not finished draining.
dripping from the bottom of the brew basket has stopped. Carefully remove the brew basket
while inspecting the inside of the basket for hot coffee that has not finished draining.
R
STOP
BREW
READY
POWER
C
A
G
H
D
E
F
B
Legend:
A-
Power switch
B-
Ready light
C-
Full/half batch switch
D-
Brew switch
E-
Brew light
F-
Brew basket
G-
Stop switch
H-
Hot water faucet
Gravity pot
Airpot