Grizzly G5749 Benutzerhandbuch

Warning: no portion of this manual may be reproduced in any shape

or form Without the Written approval of grizzly industrial, inc.

#Kn14659 printed in China

model g5749, g5750,

g5751, g5752, g5753

drill press vise

installing the vise

1. situate the vise on the drill press table so the

mounting slots are aligned with the table slots
(see

figure 1).

2. using appropriate hardware for the drill press

table, secure the vise to the table at four
points.

• DISCONNECT DRILL PRESS FROM

poWer before installing vise.

• Always wear appropriate eye protection

when drilling.

• Confirm that the vise is securely fastened

to the table before drilling.

• Always tighten the vise fully and ensure

the workpiece is secure before drilling.

• Never hold the workpiece with your hands

while drilling.

• Remove chucks and other tools from drill

press and table before drilling.

using the vise

1. ensure the vise is securely fastened to the

table.

2. set the depth stop on the drill press to pre-

vent drilling into the vise body.

3. situate the workpiece beneath the drill and

secure it in the vise (see

figure 2).

4. drill the workpiece.

figure 1. example of installing the vise.

If you need help with your new drill press vise,
call our Tech Support at: (570) 546-9663.

Maintenance

Cleaning and maintaining this vise is simple and
will ensure years of reliable service. Clean away
any debris from the vise and leadscrew. Wipe
down the vise with a lightly oiled rag. open and
close the vise at least once completely to ensure
complete coverage.

Note: Cleaning the vise is best accomplished with
a vacuum, rag, or stiff brush. Using compressed
air creates an eye injury hazard and can force
chips deeper into recesses.

figure 2. example of drilling the workpiece.