Garmin 18x Benutzerhandbuch

Seite von 38
190-00879-08 
GPS 18x Technical Specifications  
 
Rev. D 
Page 20 
4.2.15  3D Velocity Information (PGRMV) 
$PGRMV,<1>,<2>,<3>*hh<CR><LF> 
<1>  True east velocity, -514.4 to 514.4 meters/second for GPS 18x PC/LVC; -514.44 to 514.44 for GPS 
18x-5Hz 
<2>  True north velocity, -514.4 to 514.4 meters/second for GPS 18x PC/LVC; -514.44 to 514.44 for GPS 
18x-5Hz 
<3>  Up velocity, -999.9 to 999.9 meters/second for GPS 18x PC/LVC; -999.99 to 999.99 for GPS 18x-5Hz 
4.2.16  DGPS Beacon Information (PGRMB) 
Note: The GPS 18x products do not support PGRMB at this time.  
$PGRMB,<1>,<2>,<3>,<4>,<5>,K,<6>,<7>,<8>*hh<CR><LF> 
<1>  No Effect (This field is not used on this model and is included only for backwards compatibility) 
<2>  No Effect (This field is not used on this model and is included only for backwards compatibility) 
<3>  No Effect (This field is not used on this model and is included only for backwards compatibility) 
<4>  No Effect (This field is not used on this model and is included only for backwards compatibility) 
<5>  Distance to beacon reference station in kilometers 
<6>  No Effect (This field is not used on this model and is included only for backwards compatibility) 
<7>  DGPS fix source (R = RTCM, W = WAAS, N = Non-DGPS Fix) 
<8>  DGPS mode, A = Automatic, W = WAAS Only, R = RTCM Only, N = None (DGPS disabled) 
4.3  BAUD RATE SELECTION 
Baud rate selection can be performed by sending the appropriate configuration sentence to the GPS sensor as 
described in the $PGRMC
, field <10>. 
4.4  MEASUREMENT PULSE OUTPUT (GPS 18x LVC & 18x-5Hz ONLY) 
4.4.1  One-Pulse-Per-Second (PPS) Output (GPS 18x LVC Only) 
The highly accurate one-pulse-per-second (PPS) output is provided for applications requiring precise timing 
measurements. After the initial position fix has been calculated, the PPS signal is generated and continues until the 
unit is powered down. The rising edge of the signal is aligned to the start of each GPS second within 1 µs for all 
conditions in which the re  ceiver has reported a valid and accurate position for at least the previous 4 seconds. 
The NMEA 0183 sentences that follow each rising edge of the PPS signal tell when you were and where you were at 
that previous rising edge of the PPS signal, beginning with the GPRMC sentence as the lead sentence in any 
particular NMEA 0183 record. 
Regardless of the selected baud rate, the information transmitted by the GPS 18x series products is referenced to the 
pulse immediately preceding the NMEA 0183 RMC sentence. 
The accuracy of the one-pulse-per-second output is maintained only while the GPS receiver is computing a valid 
position fix. To obtain the most accurate results, the one-pulse-per-second output should be calibrated against a local 
time reference to compensate for cable and internal receiver delays and the local time bias. 
The default pulse width is 100 ms, however; it may be programmed in 20 ms increments between 20 ms and 980 ms 
as described in $PGRMC section
, field <13>. 
4.4.2  Five-Pulse-Per-Second Output (GPS 18x-5Hz Only) 
The highly accurate five-pulse-per-second output is provided for applications requiring precise timing 
measurements. After the initial position fix has been calculated, the GPS 18x-5Hz generates the pulse signal, which 
continues until power down. The rising edge of the signal is aligned to the start of each GPS second within 1 µs for 
all conditions in which the receiver has reported a valid and accurate position for at least the previous 4 seconds. 
The NMEA 0183 sentences that follow each rising edge of the Measurement Pulse Output signal tell when and 
where you were at that previous rising edge of the Measurement Pulse Output signal, beginning with the GPRMC 
sentence as the lead sentence in any particular NMEA 0183 record. 
Regardless of the selected baud rate, the information transmitted by the GPS 18x-5Hz is referenced to the preceding 
five times per-second output pulse.