Furuno 1943C Benutzerhandbuch

1. OPERATIONAL OVERVIEW 

 

 

Press the [POWER/BRILL] key to turn the unit on. A beep sounds and the 
equipment proceeds in the sequence shown below, displaying product 
information, startup test results and the chart usage disclaimer. The startup test 
checks the ROM, RAM, internal battery and backup data for proper operation, 
displaying the results for each as OK or NG (No Good). If NG appears an 
appropriate message appears on the screen. For any NG, try to press any key to 
go to the chart disclaimer screen, then perform the diagnostic test as shown in 
the paragraph “7.6 Diagnostics.”   

RADAR PLOTTER

* 

     STATION NAME:
        RADAR#
FURUNO ELECTRIC CO., LTD.
CHARTS AVAILABLE

LICENSE NO.

                 STARTUP TEST
ROM

OK

RAM

OK

INTERNAL BATTERY

OK

BACKUP DATA

OK

è

è

Host Name

Chart List

NO NATIONAL HYDROGRAPHIC
OFFICE HAS VERIFIED THE
INFORMATION IN THIS
COASTLINE DATA CARD AND NONE
ACCEPT LIABILITY FOR THE 
ACCURACY OF REPRODUCTION OR
ANY MODIFICATIONS MADE 
THEREAFTER. THIS PRODUCT WITH
THIS COASTLINE DATA CARD
DOES NOT REPLACE THE 
REQUIREMENT TO USE THE
APPROPRIATE PRODUCTS FOR
NAVIGATION ACCORDING TO
NATIONAL AND INTERNATIONAL
REGULATIONS.

PROGRAM No. 19500020XX**

** = Program version no. for
FURUNO/NAVIONICS
model. 19500010XX for C-MAP model.
XX = program version no.

* = "GD-1900C Plotter" for GD-1900C

#= Name determined at installation.

For start up with the radar display, the magnetron takes from one minute to 
two minutes and thirty seconds (depending or radar model) to warm up before 
the radar can be operated. The time remaining for warm up of the magnetron is 
counted down at the center of the display. 
 
You may press any key at the chart disclaimer screen to show the last-used 
display, or wait several seconds to let the equipment do it for you. 

 

To turn the unit off, press and hold down the [POWER/BRILL] key until the 
screen goes dark (approx. 3 sec.). To protect the LCD attach the hard cover. 
Note that the network sounder will be turned off approx. three minutes after 
turning off the power. 
 
Note: The first time you turn on the power (or any time the power is applied after 

a memory reset), you are asked if you want to start the simulation mode, 
which provides simulated operation of the equipment. Push the [ENTER] 
knob to start the simulation mode, or press the [CLEAR] key to start 
normal operation. For further details about the simulation mode, see the 
paragraph “1.10 Simulation Display.”