Friedrich SV12A10 Benutzerhandbuch

—8—

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the screw and the clamp which fastens the

capacitor.

3. Disconnect all the leads of capacitor terminals.
4. Re-install the components by referring to the

removal procedure, above. (See Figure 11)

1. Remove the cabinet. (Refer to section 2.1.2)
2. Disconnect the grounding screw from the control

box.

3. Disconnect the 2 receptacles.
4. Remove a screw which fastens the clip cord. 

(See Figure 12)

5. Remove the power cord. 
6. Re-install the component by referring to the above

removal procedure, above.
(Use only one ground-marked hole      for ground
connection.)

7. If the supply cord of this appliance is damaged, it

must be replaced by the special cord. (The 
special cord means the cord which has the same
specification marked on the supply cord attached at
the unit.)

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the 2 screws which fasten the thermostat.
3. Disconnect 2 leads of thermostat terminals.
4. Remove the thermostat.
5. Re-install the components by refering to the above

removal procedure. (See Figure 13)

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the 2 screws which fasten the rotary

switch.

3. Disconnect all the leads of the rotary switch

terminals.

4. Remove the rotary switch.
5. Re-install the components by referring to the

above removal procedure. (See Figure 14)