Zebra 49834 Benutzerhandbuch
Preventive and Corrective Maintenance
Printed Circuit Boards—Wireless PCMCIA Option Board
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
245
Wireless PCMCIA Option Board
This procedure is for installing or replacing the wireless PCMCIA option board. Read these
instructions thoroughly before performing this procedure.
instructions thoroughly before performing this procedure.
Tools Required
Installation Instructions
Refer to
and remove the print engine from the applicator.
Remove the PCMCIA Card
1.
. Remove the PCMCIA card shield by removing the shield screw.
2.
Remove any PCMCIA card from the card slot by pressing the card release button, if
necessary.
necessary.
The card release button is located inside the card slot.
Figure 128 • 170PAX4 Rear View of PCMCIA Card and Shield
Removal and Installation
Note •
You must have PAX firmware V60.13.0.4 or higher. Zebra PAX firmware is
downloadable from the Zebra web site. See
www.zebra.com
.
Phillips Screwdriver Set
Metric Nutdriver Set
Anti-Static Wrist Strap
Anti-Static Mat
Metric Hex Key (Allen Wrench) Set
PCMCIA
Card
PCMCIA
Card
Shield
Shield
Screw
PCMCIA
Card
PCMCIA
Card
Shield
Shield
Screw
Left-Hand
Right-Hand