Zebra 49834 Benutzerhandbuch
Preventive and Corrective Maintenance
Exterior Components—Control Panel
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
295
Control Panel
This procedure is for installing the replacement control panel. Read these instructions
thoroughly prior to installation.
thoroughly prior to installation.
Tools Required
Installation Instructions
1.
Refer to
and remove the print engine from the applicator and open
the rear enclosure.
Remove the Control Panel
1.
. Remove the two Allen screws that secure the control panel.
2.
. Disconnect the single interface board connector from the control panel
interface board.
Caution • A qualified service technician must perform this installation.
Caution • Turn Off (
O
) the AC power switch and remove the power cord before
performing this procedure.
Phillips Screwdriver Set
Metric Hex Key (Allen Wrench) Set
Anti-Static Wrist Strap
Anti-Static Mat
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.