Zebra 49834 Benutzerhandbuch
Data Ports
Applicator Interface Connector
57518L-001 Rev. 1
3/18/05
170PAX4 Maintenance Manual
353
Jumper Configurations for +5 V I/O Applicator Interface Board
shows the pin and jumper configurations for pins 1 and 2 in +5 V I/O operation.
Jumpers J4 and J5 are used together to produce isolated or non-isolated modes of operation for
applicator input and output control signals. J4 configures the +5 V source for the optoisolator
circuits, and J5 configures the ground. For proper operation, when J4 is installed, J5 must be
installed, and when J4 is removed, J5 must be removed.
applicator input and output control signals. J4 configures the +5 V source for the optoisolator
circuits, and J5 configures the ground. For proper operation, when J4 is installed, J5 must be
installed, and when J4 is removed, J5 must be removed.
Table 47 • Pin 1 and Pin 2 Jumper Configurations
Pin No.
Non-Isolated
Isolated
1
J5 In
I/O ground is connected to the
Applicator Interface Circuit
Ground.
I/O ground is connected to the
Applicator Interface Circuit
Ground.
J5 Out
I/O ground is disconnected from the Applicator Interface
Circuit Ground. Ground for the applicator interface
optoisolator circuits is provided externally to this pin.
I/O ground is disconnected from the Applicator Interface
Circuit Ground. Ground for the applicator interface
optoisolator circuits is provided externally to this pin.
2
J4 In
+5 V I/O is connected to the
Applicator Interface Circuit +5 V
Supply.
+5 V I/O is connected to the
Applicator Interface Circuit +5 V
Supply.
J4 Out
+5 V I/O is disconnected from the Applicator Interface
Circuit +5 V Supply. The +5 V for the applicator
interface optoisolator circuits is provided externally to
this pin.
+5 V I/O is disconnected from the Applicator Interface
Circuit +5 V Supply. The +5 V for the applicator
interface optoisolator circuits is provided externally to
this pin.