Zebra 49834 Benutzerhandbuch

Front Panel LCD Displays

57518L-001 Rev. A

3/18/05

170PAX4 Maintenance Manual

67

Use the LCD display on the front panel to adjust print engine settings. 

parameters in the order in which they are displayed when you press NEXT after entering Setup 
mode. 

 shows the additional parameters that appear when a wired or 

wireless print server is installed in the print engine.

While viewing parameters, press NEXT to continue to the next parameter, or press 
PREVIOUS 

to return to the previous parameter in the cycle. When a parameter is changed, an 

asterisk (*) appears in the upper left corner of the display to indicate that the value is different 
from the one currently active in the print engine.

Adjust Print Darkness
Darkness (burn duration) settings depend on a variety of factors, including 
ribbon type, media, and the condition of the printhead. You may adjust the 
darkness for consistent high-quality printing.

Set the darkness to the lowest setting that provides 

good print quality. If the darkness is set too high, the ink may 
smear, the ribbon may burn through, or the printhead may wear 
prematurely. 

If printing is too light or if there are voids in printed areas, increase the 
darkness. If printing is too dark or if there is spreading or bleeding of 
printed areas, decrease the darkness.

 can be used to determine the best 

darkness setting. You may want to adjust darkness while performing the 

. Because the darkness setting takes effect 

immediately, you can see the results on labels that are currently printing. 
Darkness settings also may be changed by the driver or software settings.

Default: +04.0

Range: 00.0 to +30.0

Press the right oval to increase darkness.

Press the left oval to decrease darkness.

DARKNESS     +04.0 

-                 +