INSTEON 2412N Benutzerhandbuch

Seite von 20
6
®
Rev. 6/19/2012 11:45 AM
 Web Interface Icons
Homepage
Settings
Help
Room Settings Scene Settings
Returns you to 
the SmartLinc 
homepage
Takes you 
to SmartLinc 
general settings
Takes you 
to SmartLinc 
help page on 
Smarthome 
Wiki
Add, remove 
and rename 
scenes
Add, remove 
and rename 
rooms and add 
camera URLs
• These instructions assume the user is familiar with networking setup and firewall  
    management (you will need to refer to your router’s instruction manual to determine how to  
perform the following steps on your specific router)
• User needs to be aware that there are always risks associated with configuring devices to  
    make them accessible to the Internet. User takes full responsibility for network management  
    and security. 
• You must be on your local network (same as your SmartLinc) when registering at 
     http://smartlinc.smarthome.com (final steps below).
1.  Set up port forwarding on your router.
• Log onto your router.
• Determine your router’s range of IP addresses. You 
    may need to contact your ISP.
• Choose an IP address outside that range.
• Open the port forwarding/virtual servers feature on 
    your router.
• Forward your chosen IP address plus a random port 
    of your choice (to move off the default 80 server).
2.  Set up SmartLinc authentication.
• While at home, visit http://smartlinc.smarthome.com 
    and click “I’m at home.”
• Click the Settings (wrench) icon.
• Click Authentication.
• Enter your username and password (maximum 10  
    characters of letters, numbers and “@” only).
• Click Save User Name and Password.
 Setting Up Web Interface