INSTEON 2442-422 (eu) Benutzerhandbuch
Page 6 of 24
2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM
Installation
1)
Write down the INSTEON ID found on the back of the unit (XX.XX.XX)
2)
Turn off breaker/fuse and verify that the power is off
3)
Disconnect wires from existing switch, fixture or outlet and prep all wires to be connected to Micro
module, with 3/16” (5mm) of bare wire on the ends
module, with 3/16” (5mm) of bare wire on the ends
4)
Connect wires per diagram which corresponds to your installation
Note: sense lines carry very low current (~0.35mA 240V, ~0.17mA for 120V)
5)
After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse
After a few seconds, load will turn on (if wired into switch or fixture) and Micro module LED will turn
green
green
6)
Test by tapping Micro module on/off buttons
Load will turn on and off
Micro Module LED will turn green when load is on and red when load is off
7)
If installing a single momentary or dual momentary switch
a)
Press and hold set button until it beeps