Lennox mpe-33r Benutzerhandbuch

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

In selecting this LENNOX Merit Plus electric fi replace, you have chosen the fi nest and 
most dependable fi replace found anywhere.  A beautiful and prestigious addition to 
the fi nest homes.  Welcome to a Family of hundreds of thousands of satisfi ed LENNOX 
Fireplace Owners.

Please read and carefully follow all of the instructions found in this manual.  Please 
pay special attention to the safety instructions provided in this manual.  The instruc-
tions included here will assure that you have many years of dependable and enjoyable 
service from your LENNOX product.

Important Safety Information ........... Page  2
Packaging List .................................. Page  3
Introduction ..................................... Page  3
General Information ......................... Page  3
Locating Fireplace ............................ Page  3
Tools/Supplies Required .................. Page  3
Framing Specifi cations ..................... Page  4
Fireplace Specifi cations .................... Page  4
Clearances ....................................... Page  5
Pre-installation ................................. Page 

5

Installation Steps ............................. Page  5
Electrical Connections ...................... Page  5
Final Finishing .................................. Page  6
Break-In Period ................................ Page  6
Control Panel Operation ................... Page  6
Remote Control Operation ............... Page  7
Maintenance ..................................... Page 

8

Wiring Diagrams .............................. Page  10
Troubleshooting ............................... Page  15
Replacement Parts ........................... Page  16
Optional Accessories ........................ Page  18

This assembled Electric Room Heater is 
packaged with:

•   One accessory package located in the 

fi rebox, containing; 

1. One Installation and Operation Manual.
2. One Warranty Certifi cate.
3. One Remote Control.

•   Two spare Light Bulbs are located in a 

recess on the back of the log assembly.

Do not install or operate this fi re-
place through a switch wired in the 
120 VAC or  240 VAC circuits.  The 
only approved wiring for a switch 
is through the low voltage circuit  
(24 VAC) as shown on Page 14.

120 Volt, 60 Hz, 1600 Watts:
(ref. Page 10)
Hard Wire Connection - Use two conductor, 
non-metallic sheath cable with ground wire 
(total three wires) for the incoming power 
supply.  The wire used must conform to local 
and national electrical codes for the specifi ed 
power consumption rating. See Table 1.

240 Volt, 60 Hz, 3000 Watt:
(ref. Page 11)
Use three conductor, non-metallic sheath cable 
with ground wire (total four wires) for the 
incoming power supply. The wire used must 
conform to local and national electrical codes 
for the specifi ed power consumption rating. 
See Table 1.

Low voltage wire is provided for the wall switch 
connection.  The wires gage requirements are 
shown on Table 1.

Your new fi replace may be installed into existing 
framing or built into a wall (see Figure 1).

When choosing a location for your new fi re-
place, ensure that the general instructions are 
followed.  Also, for the best effect, install the 
fi replace out of direct sunlight and away from 
overhead lighting.  See Figure 1.

TOOLS:
Phillips Screwdriver
7/16" Socket Drive
Hammer
Saw And/or Saber Saw
Level
Measuring Tape
Plumb Line
Electric Drill And Bits
Pliers
Square
Gloves

BUILDING SUPPLIES:
Framing Materials
Wall Finishing Materials
Caulking Materials 
     (noncombustible)