Lennox elite vint-dvs-u Benutzerhandbuch

Seite von 32
7
PRE-INSTALLATION
Features
Installation Options
  Residential
  Vented vertical and horizontal
  Manufactured (mobile) home
  Natural gas (NG) or propane (LP)
  Bedrooms   
 
  Optional wall­mounted or remote thermostat
 
Venting
This appliance can be vented with Secure Vent™ direct­vent pipe by Security 
Chimneys™*. Coaxial pipe diameters are 6­5/8” outer and 4” inner.  The 
combustion air for this stove is drawn from outside the house through 
the outer DV (direct­vent) pipe. Room air is not required for combustion.
When planning your installation, select the correct length of vent pipe 
for your particular requirements. Determine the minimum clearance to 
combustibles from the rear of the unit to the wall. It is also important 
to note the thickness of the wall. Before cutting the vent hole through 
the wall make sure that ALL vent and termination clearances (see Page 
17
)
 will be met.
Electrical
The standard fan motor requires 120 Volts AC for operation. The stove is 
not dependent on the fan or an outside electrical supply to operate. 
WARNING - Electrical Grounding Instructions - This appliance is 
equipped with a three-prong (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a 
properly grounded three-prong receptacle. Do not cut or remove 
the grounding prong from this plug.
Millivolt Valve
This appliance is operated with a millivolt valve and therefore burns even 
during a power outage.
Fuel
This appliance comes from the factory equipped to burn natural gas at a 
specified elevation. The appliance can be converted to burn LP gas (liquid 
propane) by changing the cassette (valve and pilot assembly) or installing a 
conversion kit. Only Lennox Hearth Products conversion kits can be used to 
convert from NG to LP or LP to NG. Contact your Lennox Hearth Products 
dealer for details.
Specifications
Stove weight: 150 lbs
Pipe:Type ­ direct­vent
Recommended manufacturer*
 
Security™ Secure Vent™*
 
Diameter ­ 6­5/8”x 4” for all installations
Stove Packaging List
The appliance comes with the following parts:
1  Stove Body with Burner Cassette
1  Log Set
1  Bag of Ember Material
1  Bag of the volcanic stone.
1  Installation and Operation Manual
Optional Parts
 
150 CFM Blower
 
Reversible Cast­Iron Panels
 
Gallo Veneziano Stone Panels
 
Soapstone Panels
 
Remote Controls
 
Digital Wall Thermostat Kit
Note: See Page 28 for ordering information.
* Other approved chimney brand is Simpson Dura­Vent DV­GS.
RATINGS
VINT-DVS-U / SDVCS
NATURAL GAS
LP GAS
Max/Min Input BTUh 0-2,000 Feet
(0-610 M)
u
27,000 / 19,500
27,000 / 21,300
Manifold Pressure (IN. WC)
3.5 / 1.8
10.0 / 6.0
Min. Inlet Pressure (IN. WC)
5.0
11.0
Maximum heat output BTUs/hour-steady state
22,140
22,140
P4 Efficiency 
w
47.00%
49.07%
Orifice (DMS) 0-2,000 Feet (0-610 M)
u
#40/.098 IN.
#53/.060 IN.
u
Unit factory equipped for 0-2000 FT/0-610 M, In Canada 0-4500 FT/0-1370 M
v
The Steady State Efficiency numbers based on maximum vent configuration.
w
Tested to CSA P.4.1-02 “Testing Method for Measuring Annual Fireplace Efficiency.
Electrical Rating: 120 VAC, 60 HZ, Less Than 2 Amps