Jacuzzi j - 200 j - 230 Benutzerhandbuch

Your spa has a self-diagnostic control system. The system will 

automatically display the following if a problem is detected.

When the actual spa water temperature reaches up to 2°F 

(1°C) above the set temperature, the spa goes into “summer 

logic.” The 24-hour circulation pump will turn off automatically 

to avoid adding additional heat to the water, eventually creating an 

overheat condition. This setting is not user-programmable.

note: The summer logic does not take effect until the spa water 

temperature reaches 95°F (35°C). This condition is more likely in 

excessively hot weather. Remember, the spa’s ability to cool is directly 

affected by the ambient temperature. An excessively hot ambient 

temperature may prevent the spa from cooling down because it’s 

fully insulated construction is designed to retain heat and to minimize 

operating costs.
14.2  panel Displays Col

Cool Condition - Temperature has dropped 20°F (11°C)  

below the current set temperature. Jets pump 1, (or 

optional circulation pump) and the heater have been activated to bring 

the temperature to within 15°F (8°C) of the set temperature. No 

corrective action is required! 

note: This condition is common during first time fill ups or during refills 

since tap water is often very cold.

Freeze Protection - A potential freeze condition has been 

detected. No action is required. Jets pump (or optional 

circulation pump) and heater will operate to circulate and warm water 

through the plumbing until spa is out of DANGER. See “Winterizing” 

Open sensor (heater is disabled) or shorted sensor (spa is  

deactivated). The high-limit temperature sensor is not 

functioning. Contact your authorized Jacuzzi dealer or qualified service 

technician.

Open or shorted sensor (heater disabled). The temperature  

sensor is not functioning. Contact your authorized Jacuzzi 

dealer or qualified service technician.

40