Kohler courage xtr-6 Benutzerhandbuch

9

The carburetor is designed to deliver the correct 
fuel-to-air mixture to the engine under all operating 
conditions. It has been calibrated at the factory and is 
not adjustable.

NOTE: To ensure correct engine operation at 

Š•’žŽœȱŠ‹˜ŸŽȱŗśŘśȱ–ŽŽ›œȱǻśŖŖŖȱĞǯǼǰȱ’ȱ–Š¢ȱ
be necessary to have a Kohler Authorized 
Service Center install a high-altitude jet kit. 
If a high-altitude kit has been installed, the 
engine must be reconverted to the original jet 
size before it is operated at lower altitudes, or 
overheating and engine damage may result.

If engine troubles appear to be fuel-system related, 
check the following areas before seeking service from 
a Kohler Authorized Service Center.

—œž›Žȱ‘ŽȱžŽ•ȱŠ—”ȱ’œȱꕕŽȱ ’‘ȱŒ•ŽŠ—ǰȱ›Žœ‘ȱ
gasoline.

Ensure the air cleaner and precleaner are clean 
and securely fastened.

Ensure the fuel tank cap vent is not blocked and 
that it is operating properly.

—œž›Žȱ‘Žȱ’—Ȭ•’—ŽȱžŽ•ȱꕝŽ›ǰȱ’ȱŽšž’™™Žǰȱ’œȱŒ•ŽŠ—ȱ
and unobstructed. Replace if necessary.

ȱŠĞŽ›ȱŒ‘ŽŒ”’—ȱ‘ŽœŽȱ’Ž–œȱ‘ŽȱŽ—’—Žȱ’œȱœ’••ȱ‘Š›ȱ
to start, runs roughly, or stalls at low-idle speed, it 
may be necessary to have the carburetor serviced by a 
Kohler Authorized Service Center.

Maintenance, repair or replacement of the emission 
control devices and systems, which are done at the 
customers expense, may be performed by any non-
road engine repair establishment or individual. 
Warranty repairs must be performed by a Kohler 
Authorized Service Center. Required maintenance 
procedures should be performed at the frequency 
˜ž•’—Žȱ’—ȱ’ž›ŽȱŗŘǯ

•

•

•

•

To shutdown the engine, turn ignition switch to OFF
™˜œ’’˜—ȱǻ’ȱŽšž’™™ŽǼǯȱ˜ŸŽȱ‘ŽȱžŽ•ȱœ‘žȬ˜ěȱ•ŽŸŽ›ȱ˜ȱ
OFFȱ™˜œ’’˜—ȱǻ’ȱŽšž’™™ŽǼǯȱŽŽȱ’ž›ŽȱŚǯ

NOTE: If the engine is equipped with an optional 

blade-brake clutch (BBC), the blade can be 
œ˜™™Žȱ ’‘˜žȱœ‘žĴ’—ȱ˜ —ȱ‘ŽȱŽ—’—Žǯȱ
For further information, refer to operating 
instructions of the equipment this engine 
powers.

Unless the equipment this engine is mounted on has 
ŠȱŸŠ›’Š‹•ŽȬœ™ŽŽȱŒ˜—›˜•ȱǻ‘›˜Ĵ•ŽǼǰȱ‘Žȱœ™ŽŽȱ˜ȱ‘’œȱ
engine cannot be altered.

NOTE: Do not tamper with governor or carburetor 

to increase engine speed. Overspeed is 
hazardous and will void warranty.

This engine will operate continuously at angles up 
˜ȱŘŖǚǰȱŠ—ȱ’—Ž›–’ĴŽ—•¢ȱž™ȱ˜ȱŘśǚȱ’—ȱŠ••ȱ’›ŽŒ’˜—œȱ˜›ȱ
one minute or less. Oil level must be at FULL mark 
on dipstick. Refer to the operating instructions of the 
equipment this engine powers. Due to equipment 
design or application, there may be more stringent 
restrictions regarding the angle of operation.

NOTE: Do not operate this engine continuously at 

Š—•ŽœȱŽ¡ŒŽŽ’—ȱŘŖǚȱ’—ȱŠ—¢ȱ’›ŽŒ’˜—ǰȱ‹ŽŒŠžœŽȱ
Ž—’—ŽȱŠ–ŠŽȱŒ˜ž•ȱ›Žœž•ȱ›˜–ȱ’—œžĜŒ’Ž—ȱ
lubrication.

To avoid engine damage due to overheating remove 
›ŠœœȱŠ—ȱ˜‘Ž›ȱ‹ž’•Ȭž™ȱŽ‹›’œȱŠĞŽ›ȱŽŠŒ‘ȱžœŽǯ

DZȱ ĞŽ›ȱ›ž——’—ȱ‘ŽȱŽ—’—Žȱ˜›ȱŠ—¢ȱ•Ž—‘ȱ˜ȱ

’–ŽǰȱŠ••˜ ȱ’ȱ˜ȱŒ˜˜•ȱ˜ —ȱœžĜŒ’Ž—•¢ȱ‹Ž˜›Žȱ
ŠĴŽ–™’—ȱ˜ȱŒ•ŽŠ—ȱ˜ěȱŽ‹›’œǯ