beiter re Benutzerhandbuch
The REST
Attaching the Support on the Bow window:
Clean the surface of the bow window. Insert a bow-square on the string
and the Beiter Rest Tool in the Beiter Rest to easily find the correct
position, as much as possible parallel to the bow square (pic. 6).
and the Beiter Rest Tool in the Beiter Rest to easily find the correct
position, as much as possible parallel to the bow square (pic. 6).
Pay attention that the Beiter Rest Tool must be inserted completely from
in the spindle from the back-side. The Beiter Rest may be used for both
RH or LH archers: LH may use the Beiter Rest Tool without the blue
sleeve, and must work from the front side of the bow, not from the
back-side as RH archers do!
in the spindle from the back-side. The Beiter Rest may be used for both
RH or LH archers: LH may use the Beiter Rest Tool without the blue
sleeve, and must work from the front side of the bow, not from the
back-side as RH archers do!
Strip off the Tape and install the Beiter Rest over the Plunger, trying to
keep the Beiter logo parallel to the bow-square(for LH the word
“SUPPORT”) and press firmly (pic. 7).
keep the Beiter logo parallel to the bow-square(for LH the word
“SUPPORT”) and press firmly (pic. 7).
The maximal adhesive power is reached on anodized handles after
about 12 hours!
about 12 hours!
Due to this position you have a 15° angle, which allows a maximal
height adjustement of 2mm.
In the factory setting (Pos. “0”) the Arrow Rest Finger touches
both white lines (pic. 8).
height adjustement of 2mm.
In the factory setting (Pos. “0”) the Arrow Rest Finger touches
both white lines (pic. 8).
By turning the Beiter Rest Tool to the left, the Arrow Rest Finger
moves to the front and therefore down (pic. 9), changing the
position of the arrow towards the Plunger, but also the Nocking
Point (which turns to be higher!).
moves to the front and therefore down (pic. 9), changing the
position of the arrow towards the Plunger, but also the Nocking
Point (which turns to be higher!).
A smaller angle when installing the Support will allow even a more
precise height adjustement, but changes also the stiffness of the
Arrow Rest Finger.
precise height adjustement, but changes also the stiffness of the
Arrow Rest Finger.
With the angle of 15°, one complete turn of the Beiter Rest Tools
moves the Arrow Rest by 0,39mm up or down.
Moving the Arrow Rest by one line (1mm) with the 15° angle,
effects a height adjustement of 0,26mm.
moves the Arrow Rest by 0,39mm up or down.
Moving the Arrow Rest by one line (1mm) with the 15° angle,
effects a height adjustement of 0,26mm.
NOW THE BEITER REST IS READY TO BE USED!
pic. 10
pic. 7
pic. 9
pic. 8
pic. 6
HOW TO INSTALL
www.WernerBeiter.com
Tel. +49 7720 856860
Fax +49 7720 4238
email: info@wernerbeiter.com
Werner Beiter
Daimlerstr. 18
DE-78083 Dauchingen
Daimlerstr. 18
DE-78083 Dauchingen
Update 01/2004