halcro-logic dm10 Benutzerhandbuch
Page 26 of 29
TM
dm10
Troubleshooting
The dm10 contains no user serviceable parts inside the compartment. Do not attempt to open
the unit as this will void the warranty and will expose you to dangerous voltages. For all
service requirements please contact your dealer or email HALCRO™ at
If the dm10 does not operate as expected first switch the dm10 back to Stand-by and then
switch the main power switch off. Once the display has turned off switch the main power
switch back on and then switch the unit from Stand-by to On. This will reset the
microprocessors in the dm10.
Symptom
Suggestion
No display characters
or illumination
Check mains power input is connected and turned on.
Check fuse.
No audio output
Ensure the input to which your source is connected is
selected.
Ensure the selected source is correctly programmed (The
light above correct input pair must be illuminated)
Ensure the output select switch is set to the correct
output mode.
Ensure the dm10 is not muted or the volume is too low.
Will not select source
Ensure the source is connected to a programmed input
and the program button adjacent to the input is
illuminated.
Will not switch to
mono
Ensure the Phono input is selected
(Mono is only available when the dm10 is in Phono
mode).
Can not de-allocate an
input
Ensure you are not trying to de-allocate an input that is
currently selected on the display screen. The software
does not allow this.
Remote control does
not work
Change batteries.
Remote transmitter may overload the receiver if too close
(100mm (4”)) to the Remote sensor window.
Remote sensor window may be blocked
If none of the above rectifies the problem please contact your dealer or contact HALCRO™ at