eutech-instruments cyberscan con 11 conductivitytds meter Benutzerhandbuch

Instruction Manual 

 

CON 11/110 

 

8

The CON meter is designed to allow you to do a one hand operation for any 
measurement or calibration. For that purpose, one electrode holder is provided. They 
are designed for easy use and installation. Care must be taken to avoid use of 
excessive force in the process of attaching this component. 

1.  Locate the slot on the right side of the meter. 
2.  Gently slide the flange of the holder into the slot of the meter. Make sure the 

holder is secured properly into the slot. 

3.  The design of the electrode holder allows you to attach it to the meter in 

different positions. 

 

 

 
 
 
 

The holder is designed for electrodes 16 mm in diameter. Electrodes larger than 16 
mm may not fit in the holder. Forcing the electrode into the opening may damage the 
holder or your electrode. 

1.  Do not use excessive force when inserting 

electrode into the holder. 

2.  Insert the conductivity electrode into the 

opening of the holder until the top housing of 
the electrode touches the top of the holder. 

The electrode holder can be attached in different 
positions for greater flexibility in measurement and 
storage purposes. 

1. Slide 

the 

elec

t

rode holder out from the slot of 

the meter. 

2. Reorient 

its 

position into appropriate orientation 

before putting back into the slot of the meter