eutech-instruments waterproof cyberscan con 400410 & tds 400 conductivitytds meter Benutzerhandbuch
Instruction Manual
CON 400/410
- 22 -
6.2 Memory
Recall
This function recalls the previous readings stored in the
memory. You can access MR from the measurement
mode only. Memory recall is in "Last In First Out" order.
To recall readings:
1. Press
the
MR/
T key once to retrieve the last
reading stored. The memory location screen – MEM,
“Loc” and the memory number – will flash on the
display.
2. Press
the
ENTER key to recall the reading stored
under that memory number.
3. Press
ENTER key again to view the date and time
the reading was taken.
4. Press
ENTER key again to return to the "memory
location" screen. The display automatically moves
to the next memory location screen.
5.
If necessary, press the MI/
S or MR/T keys to
select the next "memory location" screen; press the
ENTER/RANGE key to select the previous "memory
location" screen.
6.
Repeat steps 2 - 5 to review additional stored data
sets.
7.
To exit Memory Recall, press MEAS key to return to
Measurement mode.
NOTES:
Readings stored in memory are retained even if the units
are turned off. To erase all readings stored in memory,
use the SETUP mode P1.0 on page 27.
Figure 20 - Memory recall