bello-1 pvs4218hg assembly Benutzerhandbuch

NOTE: TWO PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS TABLE.

A. 

PLACE the CMS

®

(Cable Management System)

(1) on a soft flat surface with the shelf posts
facing upwards as shown in Fig 1. 

®

B. 

INSERT the open ends of the top (least deep)
shelf frame (2) onto the shelf posts and
SECURE with two of the shorter (M6x15) bolts
(8) as shown in Fig. 1. 

REPEAT this step for

the middle (medium depth) shelf frame (3) and
for the bottom (deepest) shelf frame (4). FULLY
TIGHTEN ALL BOLTS.

C. 

APPLY two glass pads (10) to the front of each
lower shelf frame as shown in Fig. 2. Apply
three pads to the top shelf support as shown.

D. 

CAREFULLY MOVE the table near the place it
will occupy in the room when fully assembled
and in use.

E. 

CAREFULLY POSITION the bottom (deepest)
glass shelf (7) onto the bottom shelf frame so
that the two silver discs are sitting inside the
holes at the rear of the shelf frame and
SECURE the silver discs from below the frame
with two longer (M6x25) bolts (9) as shown in
Fig. 2. DO NOT OVERTIGHTEN.  

F.

CAREFULLY stand the table upright. CARE-
FULLY POSITION the middle (medium depth)
glass shelf (6) onto to the center shelf frame so
that the two silver discs are sitting inside the
holes at the rear of the middle shelf frame (3)
and 

SECURE the silver discs from below the

frame with two longer (M6x25) bolts (9). DO
NOT OVERTIGHTEN.  

G. 

CAREFULLY POSITION the top (least deep)
glass shelf (5) onto to the top of the CMS

®

so

that the two silver discs are sitting inside the
holes at the top of the CMS

®

and 

SECURE the

silver discs from below the CMS

®

with two

shorter (M6x15) bolts (8). DO NOT OVER-
TIGHTEN.  

IMPORTANT: REMOVE THE TV AND OTHER
EQUIPMENT FROM THE FURNITURE PRIOR
TO MOVING THE ASSEMBLED UNIT. ALWAYS
PLACE THE HEAVIEST EQUIPMENT ON THE
BOTTOM SHELF.