Lowrance lmf-400 Benutzerhandbuch
28
NOTE:
Ground Speed is the default speed source for Fuel Economy.
To change Economy Speed source:
1. Press
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
. Select
F
UEL
S
ETUP
and press
ENTER
.
2. Highlight
E
CO SPEED
S
RC
and press
ENTER
to open the Economy Speed
menu. The menu has three options: Water Speed (Paddlewheel), Pitot
Speed and Ground Speed (GPS).
3. Select the desired speed source and press
3. Select the desired speed source and press
ENTER
. You will be taken
back to the main display.
Fuel Remaining Source
The Fuel Remaining source function allows you to select the device
Fuel Remaining Source
The Fuel Remaining source function allows you to select the device
used to measure the amount the fuel remaining in the tank.
NOTE:
NOTE:
If you plan to use a fluid level sensor for a fuel tank, you must
switch the fuel remaining source to Fuel Level. If you want to use
the EP-10 Fuel Flow, EP-50 Storage Device or the NMEA 2000
Suzuki Engine Interface to measure fuel remaining, select
Engine/FFlow from the Fuel Remaining Source menu.
To change Fuel Remaining Source:
1. Press
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
F
UEL
S
ETUP
and press
ENTER
.
3. Select
F
UEL
R
EM
S
RC
(Fuel Remaining Source) and press
ENTER
.
4. Highlight the device you want to use to measure remaining fuel —
E
NG
/FF
LOW
(Engine Fuel Flow) or
F
LUID
L
EV
S
NSR
(Fluid Level Sensor) —
and press
ENTER
. You will be taken back to the main display.
Reset Trip Fuel
A few sensors, like the Suzuki Engine Interface, EP-10 Fuel Flow and
A few sensors, like the Suzuki Engine Interface, EP-10 Fuel Flow and
EP-50 Storage Device keep a running total of fuel used for a trip. By
using the Reset Trip command, you can reset to zero the running total
of fuel used on a trip.
To reset trip fuel:
1. Press
To reset trip fuel:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
. Select
F
UEL
S
ETUP
and press
ENTER
.
2. Highlight
R
ST
T
RIP
F
UEL
and press
ENTER
. The Select Engine menu
will appear with up to four options (Port, Center, Starboard and All
Engines), depending on the engine-tank configuration you selected
during Boat Setup. (If you have one tank, the Press Enter to reset Trip
Fuel message will appear.)
during Boat Setup. (If you have one tank, the Press Enter to reset Trip
Fuel message will appear.)