lift-master tcr2 Benutzerhandbuch

01-17468C

DIP SWITCH SETTINGS & POWER CONNECTIONS

Step 5 Power Supply and Relay out Connections

There are six wires exiting the housing (Refer to figure
6):

RED & BLACK - POWER INPUT
BROWN & BLUE - CHANNEL 1 RELAY OUTPUT
WHITE & GREEN - CHANNEL 2 RELAY OUTPUT

FIGURE 6

Step 4 Setting DIP Switch
The TriCode

Receiver DIP switch CH1 is factory set

OFF (1-10) and CH2 is factory set ON (1-10).

Locate the 10 position DIP switch. If this is a new
installation using TriCode

transmitters, randomly set

switches matching those of the transmitter. Never use
factory settings. If receiver is used with Linear/Delta 3

Multi-code

or Stanley

transmitters, match the

receiver DIP switch to the above transmitters. Some
transmitters may use toggle switches and it may be
difficult to determine on & off. If so, try reversing the
setting on the TriCode

DIP switch (Refer to figures 4

and 5).

Note: In 'LINEAR/DELTA-3

' mode (8-bits system)

the last 2 bits (DIP #9 & 10) settings are ignored.
They can be left in either ‘ON’ or ‘OFF’ settings.

FIGURE 4

FIGURE 5