rose-displays ran-bas-cc with loop and saucer Benutzerhandbuch
Parts
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Instructions For Hanging
Step 1
Push ball up through large hole in bottom of spider
anchor. Fig. 1
anchor. Fig. 1
Step 2
Slide ball into pocket next to the hole. Pull cable
tight. Fig. 2
tight. Fig. 2
Step 3
Slide loop end of cable around center of
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 3
MultiClip. Holding clip at slight angle, first insert
one round end, then press down on other end and
push MultiClip into holder. Repeat for second
MultiClip. Fig. 3
Note: For directions on how to use a specific
holder to hang your poster, refer to the appropri-
ate instruction sheet.
holder to hang your poster, refer to the appropri-
ate instruction sheet.
Instruction Sheet
Cable/Cord Spider
TM
Anchor with Loop and Ball
Incept-10.15.01
Figure 1
Figure 2
The Spider Anchor is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #01INSLoop&Ball
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #01INSLoop&Ball
Loop and Ball
16-0018BL
Spider Anchor
RAN-BASE-CC
Figure 3