jetway v333ur1a Benutzerhandbuch

 
 
 
                                                                                                                                                                                                                                                                                                                                                         

 
 
 

 

This motherboard provides three 184-pin DUAL INLINE MEMORY MODULES (DIMM) 
sites for memory expansion available from minimum memory size of 64MB to maximum 
memory size of 3.0GB  DDR SDRAM. 
Valid Memory Configurations 

Bank 0, 1  (DDR1) 

PC1600/PC2100/PC2700 DDR SDRAM  

X1 

64MB∼1.0GB 

Bank 2, 3  (DDR2) 

PC1600/PC2100/PC2700 DDR SDRAM 

X1 

64MB∼1.0GB 

Bank 4, 5  (DDR3) 

PC1600/PC2100/PC2700 DDR SDRAM 

X1 

64MB∼1.0GB 

Total 

System Memory (Max. 3.0GB) 

3 

64MB∼3.0GB 

 

NOTE!  Make sure the total installed memory does not exceeds 3.0GB, otherwise the 

system may hang during startup. 

Generally, installing DDR SDRAM modules to your motherboard is very easy, you can 
refer to figure 2-4 to see what a 184-Pin PC1600/PC2100/PC2700 DDR SDRAM module 
looks like.  

 

           

 

 

When you install DIMM module fully into the DIMM socket the eject tab 
should be locked into the DIMM module very firmly and fit into its 
indention on both sides. 

WARNING!  For the DDR SDRAM CLOCK is set at 166MHz, use only PC2700-

compliant DDR Modules.  When this motherboard operate at 133Mhz, 
most system will not even boot if non-compliant modules are used because 
of the strict timing issues, if your DDR Modules are not PC2100-
compliant, set the DDR SDRAM clock to 100MHz to ensure system 
stability.