husky-liners 5742re Benutzerhandbuch
PART NO.
5742
5742RE~1.DOC
Rev: 2
97-01 FORD F-150 REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
•
1/8” drill bit / Drill
•
Short #2 Phillips screwdriver
•
Center punch
Package Contents
•
Driver & passenger side rear mud guard
•
#10 screw (qty. 4)
•
Instruction sheet
NOTE:
It may be necessary to remove the rear wheels for mud guard installation.
1.
Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fastener from location B (see below).
3. Attach mud guard to rear fender with the factory fastener at location B, check fit and alignment. Adjust accordingly
before tightening.
4. Using the mud guard as a template, center punch and drill 1/8” hole at locations A and C (see below).
3. Attach mud guard to rear fender with the factory fastener at location B, check fit and alignment. Adjust accordingly
before tightening.
4. Using the mud guard as a template, center punch and drill 1/8” hole at locations A and C (see below).
5.
Install #10 screws at location A and C.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.