giant-bicycles anthem Servicehandbuch

 
To determine bike’s front suspension travel adjustments and recommended 
settings, please refer to the fork manufacturer’s technical manual.  
 
A suspension fork is effective at both absorbing bump forces and helping the tire to 
track the ground for improved traction and braking control. 
 
When in active mode, a fork will rely on sag to keep the front tire in better contact 
with the ground during braking. The chart should be used as a general guideline. 
 
AIR SPRUNG FORKS 
As a general guide, pump the main chamber (main spring) to a psi equal to 70% of 
your body weight. Ride off a curb or similar object. If there is little or no movement 
from the fork, decrease psi in 10-psi increments until desired movement is 
achieved. If the fork bottoms out, increase the psi in 10-psi increments until desired 
movement is achieved.
 
To check rebound, turn the rebound damping knob (if applicable) counter 
clockwise until it stops. With full body weight, push down on the fork forcefully with 
the front brake on and watch (and feel) how the fork rebounds. Turn the rebound 
damping knob clockwise until the fork rebounds slightly slower than with no 
damping (the heavier the rider, the more damping will be required). 
 
SPRING AND ELASTOMER SPRUNG FORKS 
Springs on these types of forks are set at the factory. Most have a simple adjuster 
that allows the rider to make the fork firmer or softer depending on rider weight. 
The heavier the rider, the firmer the spring setting should be.
 

SUGGESTED FRONT SUSPENSION SAG GUIDE     (ALL TYPES) 
FORK TRAVEL (mm) 

SAG* (mm) 

75 12-15 
80 12-16 
100 15-20 
120 18-30 
145 29-37 
170 34-50 
180 36-54 
200 40-60 

 
*Manitou Forks with SPV may not sag upon initial rider weight. To check sag on an 
SPV fork, inflate the main spring cartridge to 70% of rider’s weight, and the SPV 
cartridge to 30% of rider’s weight (check the manufacturer’s technical info for 
details).