husky-liners 2240 Benutzerhandbuch

2240.DOC

Rev: 0

01/31/01

CARE AND USE INSTRUCTIONS

     Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely unroll and

lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle with a weight in each

corner (a book works well). After about 15 minutes, your liner will remain flat. In colder climates this “relaxing” may take

longer; moving the liner to a heated area will accelerate the process.

     Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The easiest way

to clean your liner is with a damp cloth or sponge. If using a cleaner, 409 ® or Glass Plus® work well. Use of Armor All®, Son-

of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR S-SERIES

CHEVROLET BLAZER/GMC JIMMY CARGO LINER

TO ACCESS THE FACTORY CARGO TIE-DOWN HOOKS
WITH YOUR LINER IN PLACE, MAKE A SLIT ACROSS THE
FOUR RAISED AREAS ON YOUR LINER (SHOWN HERE
DARKENED). THEN, PULL THE HOOKS UP THROUGH THE
SLIT IN THE LINER

FOR VEHICLES EQUIPPED WITH AN INSIDE MOUNTED SPARE TIRE, IT WILL BE NECESSARY TO TRIM
YOUR LINER BEFORE INSTALLATION.  THIS IS EASILY ACCOMPLISHED WITH A UTILITY KNIFE OR
HEAVY SCISSORS. TO TRIM, CUT DOWN THE WALL AND THROUGH THE CENTER OF THE RAISED
BAND LOCATED ALONG THE LEFT EDGE OF THE LINER (SEE ABOVE). CONTINUE CUTTING
THROUGH THE CENTER OF THE BAND UNTIL THE SECTION IS REMOVED. REMOVE THE SPARE TIRE.
NOW THE LINER CAN BE INSTALLED. ONCE THE LINER IS IN PLACE, REPOSITION THE SPARE TIRE.