King Technology pool frog above ground mineral system Benutzerhandbuch

®

•

 Turn control dial back and

forth as you pull it out of the
housing.

•

 In the back of the POOL

FROG

®

 Cycler depress center

of locking pin with a finger and
pull pin out of dial.

•

 Replace both o-rings. Apply

silicone lubricant that came with
your POOL FROG

®

 Cycler on

o-rings.

•

 Carefully insert control dial

back into housing.

•

 Replace locking pin by

pushing it through the slots on
the dial until it locks into place.

•

 Hold cap in front of you

upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and forefinger of one
hand.

•

 Take hold of the far end of

the o-ring with the thumb and
index finger of the other hand.
Roll o-ring slightly back
towards you as you stretch
the o-ring into the remainder
of the cap groove.

•

 Lubricate o-ring often with

silicone lubricant that came
with your POOL FROG

®

Cycler. DO NOT USE
petroleum based lubricants.

•

 T

o replace, simply unscrew

old knob and replace with the
new one.

®

®

12

Center of locking pin