baby-lock evolve Benutzerhandbuch

O

V

E

R

V

I

E

W

10

Your  machine is pre-set to sew an overlock with a chain stitch.  The upper blade is engaged to cut the fabric
while sewing.  Of course, you may select to engage or disengage the cutting blade.  You can change the blade
cover to the sewing table and lock the upper looper down  when sewing only the chain stitch.

down      up

A

B

C

E

D

Cutting Blade Lock Switch

Cutting blade cover and sewing table

Upper looper positioning lever

To lock cutting blade down:

Turn the dial clockwise 180 degrees to see "LOCK" on the top.

The  cutting  blade  will  stay  below  the  needle  plate  for  non-cutting

techniques.(Fig. A)

To re-engage cutting blade:

Turn the cutting blade lock switch half of a turn counter-clockwise.  The blade

will start moving automatically when you start sewing.

Cutting blade cover can be changed to sewing table for chain/cover stitching.

a) Open front cover and cutting blade cover.(See page 9, F & G)

b) Gently pull toward you to unsnap cover (Fig. B) and snap sewing table into

place (Fig. C).

c) Lower the upper looper positioning lever down (Fig.D).

d) Close the sewing table door and then the front cover. (Fig. E)

When you change from overlocking to chain/cover stitching, you should also

change the upper looper positioning lever to the "DOWN" position before you

close the sewing table door.

a) Turn the handwheel until upper looper is at its lowest position.

b) Change the upper looper positioning lever to the "DOWN" position. (Fig. D)

c) Close the sewing table door and then the front cover. (Fig. E)

Note: Make sure the upper looper positioning lever is in the "UP" position prior
to locking the machine to thread the upper looper.