baby-lock evolve Benutzerhandbuch

1. With the presser foot up and machine lock button in the locked position, see fig. A page 19, set the thread-

ing port selector lever to "C" for chain looper threading. See fig. B, page 19.

2. Set the stitch selector lever to "D" position for easy threading of the chain looper tension dial.

3. Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the telescopic antenna

thread guide extension C directly above the spool. See fig. C, page19.

4. Insert the thread through the guide above the chain looper tension dial from right to left. Bring the thread

to the back and under the thread guide, then up and over the tension dial. See fig.D inset.

5. Put thread into guide on front of dial, then down to the chain looper threading port.

6. Pull 18 inches (40cm) of thread and insert 1 inch (10cm) of thread into the chain looper threading port. Use

tweezers if necessary, to insert the thread end. see fig. E.

7. Depress the looper threading lever. See fig. E. If the thread does not go through the chain looper eye with

one push, depress the threading lever again until it does.

8. Open side cover to the left for easy access to the chain looper thread in tray. See fig. F.

9. Trim excess thread to 4 inches (10cm) from the eye of chain looper and leave it hang.

10. Close side cover.

11. Move the lock button release lever to the right.

Chain Looper