baby-lock evolve Benutzerhandbuch

The serger stitch will not unravel readily, and in most cases serged

seams are secured by an intersecting seam.

If that's not the case, these are several options for securing seam (fig.

A).

1. Leave a 3 inch (7.5cm) chain, separate the threads and tie a knot.

2. Apply a dot of seam sealant on the thread chain at the fabric edge.

Allow to dry and cut off the excess thread chain.

3. Leave a 3-4 inch (7.5-10cm) thread chain and use a large-eye tap-

estry needle or double-eye needle to weave the chain back into the

stitching.

4. Lock the beginning or end of a seam by serging over the previous

stitches.

To lock the beginning of the seam:

1. Manually turn the handwheel toward you taking 2-3 stitches into the

fabric. Leave the needle(s) in the lowest position to anchor the fab-

ric.

2. Raise the presser foot.

3. Smooth out the thread chain with your fingers (fig. B). Then bring

the chain around and under the foot, so that it aligns with the edge

of the fabric (fig. C).

4. Lower the foot and continue sewing, catching the thread chain in

the stitches for about 1inch (2.5cm). Let the blades cut off any

remaining thread chain (fig.D-E).

Securing Ends - Overlock