ge-interlogix simon 3 Benutzerhandbuch
Simon Security System
50
Panel announces that a sensor is open.
•
See Sensors section below.
Panel announces System time is not set.
•
Set the system time.
Control Panel
Panel announces Function not available when Chime Doors is pressed.
•
No sensors are programmed using sensor type 10 or 13.
Panel announces Function not available when Chime Special Motion is pressed.
•
No sensors are programmed using sensor type 25.
Panel announces Function not available when LIGHTS Time Activated is pressed.
•
No time activated lights have been programmed.
Panel announces Function not available when LIGHTS Sensor Activated is pressed.
•
No sensor activated lights have been programmed.
Panel announces Invalid. Sensor already programmed as Sensor Name.
•
This sensor is already programmed. Delete sensor if not correctly programmed.
Options (Programmable by the homeowner)
Panel does not beep.
•
Turn on (add) Option 1.
Latchkey does not function.
•
Latchkey time (option 3) is not set. Set Latchkey time.
•
Latchkey is not enabled. Enable Latchkey by pressing ARM Motion Sensors
twice.
twice.
•
The phone number is not programmed properly. Reprogram the phone number.
(options 13 or 43)
(options 13 or 43)
•
System Time is not set. Set system time.
Sensors
A sensor does not work.
•
Make sure the battery is good and installed correctly.
•
Check for interference from metal objects. Move or rotate the sensor.
•
Move the sensor to a new location.
Door or window is closed, but the panel announces it is open.
•
Be certain the arrow on the magnet and the guide line on the transmitter are
aligned and within 1/4 inch of each other.
aligned and within 1/4 inch of each other.
•
The sensor tamper switch may be open (cover off).
Motion sensors go off continuously.
•
Be sure the sensor is mounted on a solid surface and the viewing field is free from
sources of changing temperature.
sources of changing temperature.
Motion sensor does not respond to motion.
•
Make sure the sensor battery is good and installed correctly. Wait 2 minutes after
installing a new battery to test the sensor.
installing a new battery to test the sensor.
•
Adjust the sensor mounting.
•
Leave the area for 3 minutes, then retest.
•
The environment is too hot or too cold. Outdoor sensors will operate between 32°
and 120°F.