Becker dtm high speed Installationsanleitung
Subject to correction and technical modifications
37
Copyright by Becker GmbH, D-76303 Karlsbad
Installation guide
Installing the speed sensor directly on the gearbox
•
•
Release the speedometer cable and screw speed sensor onto gear-
box. Screw released speedometer cable onto the speed sensor and
connect the wires.
box. Screw released speedometer cable onto the speed sensor and
connect the wires.
Wire connections for the speed sensor
Brown
Brown
-
earth (terminal 31)
Black
-
power supply (terminal 15), 9 - 16V, 30 mA
Blue/red -
signal for socket A pin 1
Installing the speed sensor in the speedometer cable
In order to install the speed sensor, the speedometer drive cable must be
cut in one even piece for insertion of the speed sensor. When removing
the speedometer cable from the vehicle, ensure that the location of the
evenly running piece is established and marked accordingly.
In order to install the speed sensor, the speedometer drive cable must be
cut in one even piece for insertion of the speed sensor. When removing
the speedometer cable from the vehicle, ensure that the location of the
evenly running piece is established and marked accordingly.
Installation is illustrated without reference to any specific vehicle. In
addition to the sensor, the following VDO universal parts are required:
1 x connecting piece
addition to the sensor, the following VDO universal parts are required:
1 x connecting piece
1040 1300 025
(VDO part number)
2 x knurled nuts1
040 1000 003
(VDO part number)
2 x hose sleeves
1040 1000 031
(VDO part number)
2 x dogs1
040 1000 049
(VDO part number)
2 x friction washers
1040 0900 003 300 (VDO part number)
2 x fuel washers 4.0
KN07.0570.18
(VDO part number)
2 x washers
KN11.1904.122
(VDO part number)
An appropriate, complete kit from VDO (part number X 39397106191)
can also be used.
can also be used.
GAL signal
A
Figure 1