Panasonic CZRWSU3 Bedienungsanleitung
4
Part Names
REMOTE CONTROLLER
1
2
3
4
4
5
6
7
8
9
10
12
11
13
14
14
15
16
One remote controller can control a group of
up to eight indoor units.
1. Operation Display
up to eight indoor units.
1. Operation Display
Displays the operation status. (The figure
shows all the statuses.)
• The auto-flap display may be different,
shows all the statuses.)
• The auto-flap display may be different,
depending on the installed unit.
2. Start/Stop button
Pressing this button once starts and
pressing again stops the operation.
pressing again stops the operation.
3. Fan speed button
4. Swing/Wind Direction button
5. Timer setting button
4. Swing/Wind Direction button
5. Timer setting button
Use for operating with a timer.
6. Reset button
Use this button after changing the batteries.
7. Cover
Press at the top center and then slide
down.
down.
8. Transmitter
9. Remote control sensor
9. Remote control sensor
Detects the temperature at the remote
controller when detection has been
switched to the remote controller by the
sensor button.
controller when detection has been
switched to the remote controller by the
sensor button.
10. Temperature setting buttons
raises the temperature setting 1 °C
at a time.
lowers the temperature setting 1 °C
at a time.
11. Filter button
CZ-RWSC3
Press to turn off the filter lamp on the
receiver.
receiver.
12. Mode Select button
Press to switch the operation mode.
13. Ventilation button
Use this when connected to an aftermarket
fan. Pressing this button starts and stops
the fan. When the air conditioner is started
or stopped, the fan starts or stops at the
same time. (
fan. Pressing this button starts and stops
the fan. When the air conditioner is started
or stopped, the fan starts or stops at the
same time. (
appears on the display of
the remote controller when the fan is
operating.)
operating.)
14. Address button
15. Sensor button
15. Sensor button
Used this to activate the temperature
sensor on the remote controller instead of
the one on the indoor unit. The temperature
sensor on the indoor unit is selected before
shipment. At this time is shown on the
display.
sensor on the remote controller instead of
the one on the indoor unit. The temperature
sensor on the indoor unit is selected before
shipment. At this time is shown on the
display.
16. Clock button
Use this to set the clock.
From this page, the names of remote
controller’s buttons will be indicated with the
above illustrations.
E.g.: Start/Stop button
controller’s buttons will be indicated with the
above illustrations.
E.g.: Start/Stop button
CZ-RWSU3取説_簡単ガイド.indd 4
CZ-RWSU3取説_簡単ガイド.indd 4
2016/07/19 11:55:28
2016/07/19 11:55:28