Panasonic TX32DW334 Bedienungsanleitung

English   - 18 -

Event Details (Info button): Displays detailed 

information about selected events.

Filter (Blue button): Views filtering options.

Use the directional buttons to highlight an event and 

press 

OK button to display Event Options menu. The 

following options are available.
Select Channel: Using this option, you can switch to 

the selected channel.

Set Timer on Event / Delete Timer on Event: After 

you have selected an event in the EPG menu, press the 

OK button. Select Set Timer on Event option and press 

the 

OK button. You can set a timer for future events. 

To cancel an already set timer, highlight that event and 

press the 

OK button. Then select Delete Timer on 

Event option. The timer will be cancelled.

Press the 

Text button to enter. Press again to activate 

mix mode, which allows you to see the teletext page and 

the TV broadcast at the same time. Press once more 

to exit. If available, sections in the teletext pages will 

become colour-coded and can be selected by pressing 

the coloured buttons. Follow the instructions displayed 

on the screen.

Press the 

Text button to view digital teletext information. 

Operate it with the coloured buttons, cursor buttons 

and the 

OK button. The operation method may differ 

depending on the contents of the digital teletext. Follow 

the instructions displayed on the digital teletext screen. 

When the 

Text button is pressed again, the TV returns 

to television broadcast.

Your TV is capable of finding and updating the firmware 

automatically via the broadcast signal. 

On the main menu select 

Setup and press the OK 

button.

 Setup Menu will be displayed. Then select 

More and press the OK button. Navigate to Software 

upgrade  and press the OK button. In Upgrade 

options menu select Scan for upgrade and press 

OK button to check for a new software upgrade.
If a new upgrade is found, it starts to download 

the upgrade. After the download is completed 

confirm the question asking about rebooting the 

TV by pressing the 

OK to continue with the reboot 

operation.

Your TV will search for new upgrades at 3:00 o’clock if 

Automatic scanning option in the Upgrade options 

menu is set to 

Enabled and if the TV is connected 

to an aerial signal. If a new software is found and 

downloaded successfully, it will be installed at the 

next power on. 

Make sure the power cord is plugged in securely to 

wall outlet. Check if batteries are exhausted. Press 

the Power button on the TV. 

•  Check if you have selected the correct TV system.
•  Low signal level can cause picture distortion. Please 

check antenna access.

•   Check if you have entered the correct channel 

frequency if you have done manual tuning. 

•  The picture quality may degrade when two devices 

are connected to the TV at the same time. In such 

a case, disconnect one of the devices.

• This means your TV is not receiving any transmission. 

Make sure the correct source has been selected.

• Is the antenna connected properly? 
• Is the antenna cable damaged? 
• Are suitable plugs used to connect the antenna? 
• If you are in doubt, consult your dealer.

• Check if the TV is muted. Press the 

Mute button or  

increase the volume to check.

• Sound may be coming from only one speaker. Check 

the balance settings from 

Sound menu.

• The batteries may be exhausted. Replace the 

batteries. 

• If you cannot select an input source, it is possible 

that no device is connected. If not;

• Check the AV cables and connections if you are 

trying to switch to the input source dedicated to the 

connected device.