Panasonic TY-ST58PF20 Bedienungsanleitung

Seite von 122
20
4.  Setup and wiring of connected devices
   Insert the five clampers  in any of the six 
clamper attachment holes on the back side of  the 
left and right support columns at positions that 
make wiring easy. Wire as shown in the figure.
   Place cover stickers  in unused spare holes on 
the sides and back of the support columns and 
other locations. 
Note
Do not bundle the connection cables and main lead 
together.
5.  Preventing falling over
 
 In order to prevent the unit from falling over, fix 
the left and right support columns using strong 
cords or wires passed between the top and 
bottom brackets for plasma display, and connect 
them without slack to sturdy pillars or walls.
(Use commercially available cord or wire to 
prevent falling over.)
The distance between the pillar or wall and 
the rear of the plasma display must be 1 m 
(39.4 inches) or less.
Strong cords or wires 
available on the market
   [For safety reasons, always use the overturn/fall prevention accessories]
 
 The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall 
prevention accessories. 
 * 
 
The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or 
falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will 
be effective in all earthquake situations. 
Assembly
English
Clamper 
Main lead and 
various cables
Cover stickers 
Main lead 
and various 
cables