Panasonic kx-tg8120fx Bedienungsanleitung

Seite von 6
 5 
6
Frequently asked questions
Question
Cause & solution
What kind of power outlet 
should I connect the AC 
adaptor to?
Connect the AC adaptor to a 220–240 V outlet. 
Why is w flashing?
L
The handset is too far from the base unit. Move closer.
L
The AC adaptor is not connected. Check the 
connections.
L
You are using the handset or base unit in an area with 
high electrical interference. Place the handset and base 
unit away from interference sources, such as antenna 
and mobile phones.
L
The handset is not registered to the base unit. Register it.
"
 (middle soft key) i 
N i # i 
Registration
 i # i 
Register H.set
 i 
#
 i Select a base unit number. i # i Press 
and hold {x} on the base unit for about 3 seconds, until the 
registration tone sounds. i Wait until 
Enter Base 
PIN
 is displayed. i Enter the base unit PIN (default: 
0000
). i #
Why can I not make calls?
The dialling mode setting is incorrect. Set to 
Tone
 or 
Pulse
 as needed.
Why is the handset display 
blank?
L
The handset is in screen saver mode. Press {ih} to 
activate the handset display again.
L
The handset is not turned on. To turn the power on, press 
{ih}
 for about 1 second.
What should I do when the 
handset does not turn on?
L
Make sure that the batteries are installed correctly. 
L
Fully charge the batteries.
L
Clean the charge contacts and charge again.
How long should I charge new 
batteries?
Charge the batteries for about 7 hours.
How long is the battery 
operating time?
When you are using fully-charged Ni-MH batteries 
(included batteries);
In continuous use: 12 hours max.
In continuous standby mode: 150 hours max.
L
It is normal for batteries not to reach full capacity at the 
initial charge. Maximum battery performance is reached 
after a few complete cycles of charge/discharge (use).
L
Actual battery performance depends on a combination of 
how often the handset is in use and how often it is not in 
use (standby).
TG8100_8120FX(e-e)_QG.fm  Page 5  Tuesday, March 28, 2006  7:32 PM