Panasonic PT-LB20NTU Netzwerkanleitungen
43
Using WebBrowser
(cont.)
■ Setting the infrastructure mode
You can make the setting for infrastructure mode (connection through the access point
(AP) ); however, confirm to your system Administrator before changing any settings.
(AP) ); however, confirm to your system Administrator before changing any settings.
Network setting window
Click [Network setting] on the
menu.
menu.
1
2
Click [Next].
The Settings window appears.
IP ADDRESS
DHCP ON : Check this if the AP supports DHCP.
DHCP OFF : Check this if the AP does not support DHCP, and make the
DHCP OFF : Check this if the AP does not support DHCP, and make the
following settings:
IP ADDRESS
: IP address designated for projector
SUBNETMASK : SubNetMask used by the AP
GATEWAY
GATEWAY
: IP address of GateWay registered in the AP
MODE
Check “INFRASTRUCTURE”
(If this is performed directly at the computer rather than via the AP, check
“802.11 AD-HOC.”)
(If this is performed directly at the computer rather than via the AP, check
“802.11 AD-HOC.”)
SSID
Enter SSID registered in the AP.
(If this is connected in AdHoc mode, set the SSID of the computer.)
(If this is connected in AdHoc mode, set the SSID of the computer.)
(Continued on next page)