Panasonic S-ICX Handbuch
S-ICX-4.5-200
S-ICX (International) issued June 2000
17
Trunk/
Tie
Line Cards
Loop Start Trunk Card - LTRK/4 (VB-44514
UK
)
This Loop Start Card supports up to 4 loop start exchange lines and can be installed in any
flexible slot.
flexible slot.
Loop Start Trunk Card - LTRK/8 (VB-44510
UK
)
The Loop Start Card supports up to 8 loop start exchange lines and can be installed in any
flexible slot.
flexible slot.
ISDN Primary Rate Interface Card (T/S-point) - PRI/30 (VB-44540
UK
)
This supports T-point Integrated Services Digital Network (ISDN) Primary Rate Interface (PRI)
(30B+D/2 M kbps) and also S-point ISDN PRI.
(30B+D/2 M kbps) and also S-point ISDN PRI.
The PRI card can be set to support either 8, 16, 24, or 30 channels.
Unlike most other cards, due to the interaction between card slots, the PRI card must be installed in
specific Free Slots. With the S-ICX new high-density design, no other neighboring slots are restricted
when this card is installed.
specific Free Slots. With the S-ICX new high-density design, no other neighboring slots are restricted
when this card is installed.
T-point PRI requires a DSU (Digital Service Unit) for connection to the carrier circuit.
A Network Sync card is also required.
A Network Sync card is also required.
ISDN Basic Rate Interface Card (T-point) - TBRI/4 (VB-44530)
This supports T-point Integrated Services Digital Network (ISDN) Basic Rate Interface (BRI)
(2B+D:144kbps). This card can be installed in any flexible slot. Up to 4 T-point ISDN lines can be
connected to each TBRI/4 Card.
(2B+D:144kbps). This card can be installed in any flexible slot. Up to 4 T-point ISDN lines can be
connected to each TBRI/4 Card.
The T-point BRI Unit supports information transferring capability (speech and data) at the trunk.
The TBRI/4 Card connects via NT1 (Network Termination Unit/Type 1) to the T-point ISDN interface.
ISDN Interface Card (S-Point/T-Point) - STBRI/4 (VB-44531)
This ISDN Basic Interface (2 B+D: 144 kbps) card is mounted in a flexible slot, and can be switched to
either S-point or T-point use by the port base.
either S-point or T-point use by the port base.
When more than one circuit is used for T-point, the card is connected through a Network Termination
Unit (NT1) to the ISDN trunk, which supports the T-point ISDN basic interface.
Unit (NT1) to the ISDN trunk, which supports the T-point ISDN basic interface.
The card has an on-board, 4-ciucuit T-point ISDN basic interface and lightning arrester built-in. It also
provides a network clock synchronizing function.
provides a network clock synchronizing function.
AC15 Card - AC15/4 (VB-445
7
0)
This card supports the AC15 tie line interface (Speech pass 4W/2W, Control line 4W). The signaling
methods that are supported include Immediate and Wink methods. Each AC15 card includes
4 circuits.
methods that are supported include Immediate and Wink methods. Each AC15 card includes
4 circuits.
When installed in any flexible slot, the AC15 card supports call signal detection and answer from other
PBX or carrier equipment, calling to the AC15 tie line, dial sending and speech.
PBX or carrier equipment, calling to the AC15 tie line, dial sending and speech.
The AC15 interface can connect to another PBX with AC15 capability.
External safety devices (available from standard telecommunications suppliers) are required when
installing this unit outside the building.
installing this unit outside the building.