Panasonic S-ICX Handbuch

Section 700 - Operation

Chapter 3. System Features

S-ICX-10-700

S-ICX (International) issued January 2000

 29

If the received Caller ID phone number matches any number in the System Speed Dials (SSD) 
(SSD000-SSD199), then the associated SSD name can be displayed as the Caller ID information 
instead of the Caller ID phone number. Alternatively, the Direct Dial Inward (DDI) name may be 
displayed instead.

•

Loop-start trunk card (VB-44510 or VB44514) 

•

Caller ID circuit card (VB-44513 or VB-44515)

•

ISDN (PRI = VB-44540UK, BRI = VB-44530UK)

•

The system may be set to display Caller ID in one of two priorities as follows:

•   CID name (future feature)

•   Alpha tagging if matched

•   DDI name

•   DDI name

•   CID name (future feature)

•   Alpha tagging if matched

•

Currently Caller ID only supports the single format (number only). Multiple format (number and 
name) is not currently available but is planned as a future feature.

•

Caller ID Call Logging only shows the CID number.

Centrex/PBX Compatibility allows the System to be connected behind centrex or PBX lines. 

The System supports up to 6 access codes for dialling centrex or a PBX. These access codes allow the 
System, System Message Detail Recording (SMDR) (Call Logging) output to exclude the number 
dialled to reach a centrex or PBX line. 

When connected behind a PBX or Centrex, Toll Restriction Service (TRS) (Call Barring) can be used 
to restrict calls.

The System also supports transmission of a flash signal over the centrex or PBX link.

•

N/A