Panasonic TH-50PH30E Bedienungsanleitung

Adjust the horizontal position.

Adjust the vertical position.

Adjust the horizontal size.

Adjust the vertical size.

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, 
adjust so that any such noise is minimized.

(During Component/PC input signal)
Eliminate the fl ickering and distortion.

(During Component/PC input signal)
Adjusts the clamp position when black parts of the image have no detail due to underexposure or are 
tinged with green.
Optimum value for Clamp Position adjustment
When black parts have no detail due to underexposure (blackout)
→ Value that causes least blackout is the optimum.
When black parts are tinged with green
→ Value that cancels the greenishness without causing blackout is the optimum.

Over scan Turn image over scan On/Off.

Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/60p, 
1125/50p, 1125/30p (Component Video, RGB, DVI, HDMI)

            On                                 Off
Notes:
•  When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.
•  When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 42)

•  If the dot clock frequency of an analog signal is 108 MHz or higher, “Dot Clock” and “Clock Phase” 

cannot be automatically corrected.

• When digital signal input, Dot Clock and Clock Phase cannot be made.

•  Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright 

image with borders and other objects are clearly shown, and then try auto setup again.

•  Depending on the signal, out of alignment may occur after Auto Setup. Carry out fi ne tuning for the 

position/size as required.

•  If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz, 

1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA Mode” (see 

page 38) may results in correct Auto Setup.

•  Auto Setup does not work well when a signal such as additional information is superimposed out 

of valid image period or intervals between synchronizing and image signals are short, or for image 

signal with tri-level synchronizing signal added.

•  If Auto Setup cannot adjust correctly, select “Normalise” once and press ACTION ( ), then adjust 

Pos./Size manually.

While the Pos./ Size display is active, if either the N button on the remote control is pressed at any time or the ACTION 
(  ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.

Normalise