Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Техническое Руководство

The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on 
the AIM card. Apply the chassis label as follows:

If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the 
perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.

Peel the chassis label from its backing.

If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is 
available on the back of the chassis, apply the label to the top cover at the back edge. The label must be 
visible with the chassis installed. See 

 for a typical label location on the back of a chassis.

Do not apply the AIM label to a blank cover plate; to any removable network module or interface 
card; or over any holes, screws, or existing labels.

120376