Cisco 2600 2 PORT WAN ASYNC/SYNC SERIAL MODULE Техническое Руководство
maui−soho−01(config−if)#dialer in−band
maui−soho−01(config−if)#dialer map ip 10.0.0.2 name maui−nas−01 broadcast 5551111
!−−− The above commands are part of a broader Dial−on−Demand Routing (DDR)
!−−− configuration.
To connect a modem to this interface, refer to Configuring Dialout using a Modem on the AUX Port. Even
though the document refers to the AUX port, the configuration is very similar.
though the document refers to the AUX port, the configuration is very similar.
Issue the physical−layer sync command or the no physical−layer async command to revert to the default
sync mode. To configure the interface for normal serial operation, refer to Configuring Serial Interfaces.
sync mode. To configure the interface for normal serial operation, refer to Configuring Serial Interfaces.
Related Information
Multilink PPP Across Two Serial Physical−layer Async Interfaces
•
Online Insertion and Removal of Analog and Digital Modem Network Modules Installed in the
Cisco 3660 Router
Cisco 3660 Router
•
Dial Technology Support Pages
•
Technical Support − Cisco Systems
•
All contents are Copyright © 1992−2005 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Updated: Sep 14, 2005
Document ID: 7259
Cisco − 2−Port Async/Sync WAN Interface Card (WIC−2A/S)