Screen Innovations 1 Series Benutzeranleitung

1. 

To mount to a ceiling or wall, insert wood screws into 
structural wall or ceiling studs (diagram A),  insuring 
the brackets are level

.  Then hang the screen on the up-

per and lower hooks (Diagram C) and tighten the locking 
screw. 

2.  To hang the screen from a user supplied tether, mount the 

ceiling hanger to the bracket using 2 M6 screws per bracket 
as shown in Diagram B.  Then attach the bracket to the 
screen (Diagram C) securing the bracket by tightening the 
locking screw.  Use the hanger’s hole to hang the screen.  
Only use tethers and hardware of adequately rated weight 
capacity. 

3.  To un-mount a unit, simply loosen the locking screw 

and lift unit off the hooks. 

 

4.   Once power is connected to the wall from the 

back of the unit, it can be controlled via 
manual control, the internal or external IR 
receiver, IR remote, wall switch (wire dia-
gram G), or 12 volt-trigger (diagrams 
D,F,G).  12 volt and IR can be utilized in 
combination. Note, manual control is a push
-button located at the bottom left hand cor-
ner. 

  5.  Setting the screens motion limits (stop points): Locate the limit adjustment screws on the motor from under the screen 

at the left end.  Using the provided Allen key rotate the limit screws as indicated in Diagram E to individually adjust the 
top and bottom points at which the screen will stop during operation.  You will need to manually raise and lower the 
screen to see some of your adjustments.  

 

 

 

˖ 

11110000 00010001 11011101 11011110 

  STOP

˖ 

11110000 00100001 11001100 11011101 

 DOWN

˖ 

11110000 01000001 11101110 00011111  

 

VIDEO